Can I use ServletExec with ArcIMS on Windows Vista or Windows 2008?
Yes, but there are some caveats you must understand first:
The first version of ServletExec to support Vista/2008 is SE 6.0.
Versions of SE prior to 6.0 are not supported on Vista/2008.
The first version of ArcIMS to support ServletExec 6.0, and to support Vista/2008 will be
ArcIMS 9.3 (not yet available at the time of this writing).
ArcIMS "hooks into" ServletExec via the ArcIMS Servlet Connector (a Servlet and set of supporting code & resources
that ESRI wrote). Any servlet that runs on SE 5.x should run perfectly fine on SE 6.x. So technically... an ArcIMS
Servlet Connector that runs fine on SE 5.x should also run fine on SE 6.x. However, ESRI may not officially support
that unless the ArcIMS Servlet Connector you are running on SE 6.x is the one that came from ArcIMS 9.3. You'd need to check with ESRI about that.